Futek IHH200 Digital Display Manual de usuario descargar pdf (Pagina 6)

10 Thomas, Irvine, CA 92618 USA T (949)-465-0900 F (949)-465-0905 [email protected] www.futek.com/support/IHH200

IHH200 Manual 2.5 - Page 6

Electrical Connection Information

Sensor Connections

The standard sensor connection is a 5 pin 723 series Binder connector. The wiring for this is detailed below:

PIN 1! +ve Excitation

PIN 2! -ve Excitation, TEDS Common

PIN 3 ! +ve Signal

PIN 4! -ve Signal

PIN 5! TEDS

RS232 Connections

If the IHH200 has been ordered with the optional RS232 output, then this will be available via a 7 pin 723

series Binder connector. The wiring for this is as detailed below:

PIN 1! Tx

PIN 2! Rx

PIN 3 ! Gnd

Internal Connections

It may be necessary from time to time to know what the internal connections are. For example, if you disturb some of

the connections whilst trying to insert the range legends, or if you need to change the internal shunt calibration resistor.

These are shown below for reference only:

Sensor Connections

Shunt Calibration

Resistor

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Sin comentarios

Futek IHH200 Digital Display Manual de usuario Pagina 6