Futek IHH200 Digital Display Manual de usuario descargar pdf (Pagina 13)

10 Thomas, Irvine, CA 92618 USA T (949)-465-0900 F (949)-465-0905 [email protected] www.futek.com/support/IHH200

IHH200 Manual 2.5 - Page 13

Calibration Menu

To enter the CALIBRATION MENU, press and hold the and buttons for 3 seconds.

Parameter

Set-Up Information

Press To skip to next menu item

Press To change sensor input sensitivity

This allows the calibration engineer to change the sensitivity range of the IHH200 when

connecting to sensors with a sensitivity of greater than 5mV/V. The IHH200 is factory set

for 5mV/V. To ensure the unit is set to 5mV/V press

To select 50mV/V you need to power down the unit and access the internal circuit board.

Move link LK1 and place it onto JP1. Power on the IHH200 and return to this point of the

calibration menu. You will notice that the menu parameter has changed to SEnS 50.0;

press to change the sensitivity to 50mV/V and move on to the next parameter.

Press to skip to next menu item

Press to the set the display resolution

This parameter sets the decimal point position for the display and the resolution, i.e. a

value of 000.005 would display the reading to 3 decimal places and the readings will

change in steps of 0.005.

The decimal point position is moved one place to the right each time you press the

and together.

Any value can be entered for the resolution, using the and arrows to select a

digit and the and arrows to increment or decrement the digits. Press to

accept the value and move onto the next parameter.

To save the settings and move on to the next parameter press

THIS MENU IS DISABLED WHEN TEDS IS ENABLED

Press to skip to next menu item.

Press to the enter the calibration routine

If you have chosen to enter the calibration routine you will be prompted whether you want

to select LiVE. If you do not press , press . You will then be prompted to select

either of the other calibration methods, which in order, are tAbLE and CAL VAL. To select

any of the calibration methods press . Otherwise press

For more detailed calibration information, please refer to the calibration section of the

manual.

SENS 5.0

SET rES

CALibrAt

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Sin comentarios

Futek IHH200 Digital Display Manual de usuario Pagina 13